
Fixture Installation
Sinks, faucets, toilets, and disposals installed and replaced.
- Old shut-off valves deserve a check before anything comes off, because a stop that hasn't been turned in years is often the part that fails.
- A new fixture has to match the existing supply and drain positions, which is better found out before the install than during it.
- Setting a toilet properly means a fresh wax ring and a level, square set, not just tightening it down.
- Every fixture is run and checked underneath for drips before the job is done.
Sinks, faucets, toilets, disposals, outdoor spigots. Simple work, where doing it properly mostly means the parts underneath that nobody photographs.
Replacing the supply lines and shutoff valves during the job is usually worth it. A twenty-year-old chrome-plated angle stop that has not been turned in years will seize or weep the moment it is touched, and replacing it then costs a fraction of a separate visit.
A new fixture should be leak-tested with water running, and the trap watched for a few minutes. That is where a bad slip joint shows itself; otherwise it shows itself on the ceiling below.
Bought your own fixture? Some designs give more trouble than others, and it is worth asking before it goes in.
We handle fixture installation across Elmont, Franklin Square, Valley Stream, Freeport, Baldwin and the surrounding towns. See the full coverage area.
Ready when you are.
Call now or send a quick message — we'll get right back to you.